2-274
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd service-provider
cable telco-return spd service-provider
To include the service provider name in the SPD, use the
cable telco-return service-provider
command
in cable interface configuration mode. To remove the parameter from the SPD, use the
no
form of this
command.
cable telco-return spd
spd-number
service-provider
spd-string
no cable telco-return spd
spd-number
service-provider
Syntax Description
Defaults
No default behavior or values
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command sets the Service Provider Name parameter for the specified SPD in the Telephony
Channel Descriptor (TCD) messages.
Note
This command is available only in images that support telco-return. These images have a “t” as part of
the image name.
Examples
The following example shows the service provider name being set to “san_jose” for SPD 2:
router(config-if)#
cable telco-return spd 2 service-provider san_jose
Related Commands
spd-number
Service provider descriptor number for which this parameter is set.
Valid range is 1 through 5.
spd-string
Alphanumeric string that identifies the service provider.
Release
Modification
12.0(4)XI
This command was introduced.
Command Description
cable telco-return enable
Enables telco-return functionality.
cable telco-return interval
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
cable telco-return
registration-ip
Selects a different IP address for the telco-return CM to send its
registration requests.
cable telco-return spd dhcp-
authenticate
Indicates that telco-return CMs must use a specific DHCP server.
