2-317
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable upstream hop-priority
cable upstream hop-priority
To configure the priority of the corrective actions to be taken when a frequency hop is necessary due to
ingress noise on the upstream, use the appropriate
cable upstream hop-priority
command in cable
interface configuration mode.
cable upstream
n
hop-priority frequency modulation channel-width
cable upstream
n
hop-priority modulation frequency channel-width
cable upstream
n
hop-priority frequency channel-width modulation
Syntax Description
Defaults
The default priority is
frequency
,
modulation
, and
channel-width
.
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command specifies the priority of the corrective actions that should be taken when a frequency hop
is necessary to correct excessive ingress noise on an upstream. For example, if the upstream on a
Cisco uBR-MC16S card is set for the default settings (
frequency
,
modulation
, and
channel-width
), the
following occurs when the upstream noise exceeds the CNR threshold value for the current modulation
profile:
1.
The Cisco uBR-MC16S changes to a new frequency, if a clean frequency is available in its spectrum
group.
n
Specifies the upstream port. Valid values start with 0 for the first
upstream port on the cable interface line card.
frequency, modulation,
channel-width
Specifies the priority of corrective actions to be taken when ingress
noise occurs on a downstream.
Note
The
channel-width
option must come after the
frequency
option, either immediately or after the
modulation
option, as
shown in the above examples.
Release
Modification
12.1(7)CX1
This command was introduced for Cisco uBR7200 series routers
using the Cisco uBR-MC16S cable interface line card.
12.2(8)BC2
Support was added for the Cisco uBR10012 router and the
Cisco uBR-LCP2-MC16S cable interface line card.
12.2(11)CY, 12.2(11)BC3
Support was added for the Cisco uBR10-MC5X20S cable interface
line card on the Cisco uBR10012 router.
12.2(15)BC2
Support was added for the Cisco uBR10-MC5X20U cable interface
line card on the Cisco uBR10012 router.