2-324
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable upstream load-balance group
•
Load balancing is done only on a per-chassis basis—all interfaces in a load-balance group must be
in the same chassis.
Examples
The following example shows how to assign the first four upstreams for cable interface 5/1 to load
balance group 14:
Router#
config terminal
Router(config)#
interface cable 5/1/0
Router(config-if)#
cable upstream 0 load-balance group 14
Router(config-if)#
cable upstream 1 load-balance group 14
Router(config-if)#
cable upstream 2 load-balance group 14
Router(config-if)#
cable upstream 3 load-balance group 14
Router(config-if)#
Related Commands
Command
Description
cable load-balance
exclude
Excludes a particular cable modem, or all cable modems from a particular
vendor, from one or more types of load-balancing operations.
cable load-balance
group (global
configuration)
Creates and configures a load-balance group.
cable load-balance
group (interface
configuration)
Assigns a downstream to a load-balance group.
cable load-balance
group interval
Configures the frequency of the load-balancing policy updates.
cable load-balance
group policy ugs
Configures how the Cisco CMTS should load balance cable modems with
active unsolicited grant service (UGS) service flows.
cable load-balance
group threshold
Configures the threshold values that a load-balance group should use for
load-balancing operations.
clear cable load-
balance
Clears the counters or state machine used to track load-balancing
operations.
show cable load-
balance
Displays real-time statistical and operational information for load-
balancing operations.