2-403
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
enforced qos-profile
An enforced QoS profile must have been already created on the CMTS before you can assign it to an
enforce-rule. If the rule does not exist, the system displays an error message.
When the
no-persistence
option is specified, the enforced QoS profile is still automatically applied to
subscribers that violate their bandwidth requirements. However, when the cable modem reboots, the
Cisco CMTS allows the cable modem to use the QoS profile that is specified in its DOCSIS
configuration file.
The
no-persistence
option can be used when initially using the subscriber traffic management option so
as to identify potential problem applications and users. When repeat offenders are identified, they can
then be assigned enforce-rules that do not use the
no-persistence
option, so that they remain in the
penalty period even if they reboot their cable modems.
Note
The system automatically applies the enforced QoS profile to violators only if the enforce option has
been used with the
activate-rule at-byte-count
command.
Examples
The following example shows profile 12 being assigned as the enforced QoS profile to an enforce-rule:
Router#
configure terminal
Router(config)#
cable qos enforce-rule residential
Router(enforce-rule)#
enforced qos-profile 12
Router(enforce-rule)#
exit
Router(config)#
The following example shows profile 12 being assigned as the enforced QoS profile to an enforce-rule,
but with the
no-persistence
option specified, so that the enforced QoS profile does not remain in force
if the cable modem reboots:
Router#
configure terminal
Router(config)#
cable qos enforce-rule residential
Router(enforce-rule)#
enforced qos-profile 12 no-persistence
Router(enforce-rule)#
exit
Router(config)#
The following example shows the error message that is displayed when the specified QoS profile does
not exist on the CMTS:
Router#
configure terminal
Router(config)#
cable qos enforce-rule test
Router(enforce-rule)#
enforced qos-profile 98
The qos profile 98 doesn't exist or it's a cm created QoS profile
Router(enforce-rule)#
Related Commands
Command
Description
activate-rule at-byte-
count
Specifies the number of bytes that a subscriber can transmit during the
monitoring period.
cable qos enforce-rule
Creates an enforce-rule to be used to enforce a particular quality of service
(QoS) profile and enters enforce-rule configuration mode.
enabled
Activates an enforce-rule and begins subscriber traffic management.
monitoring-duration
Specifies the time period and sample rate to be used for monitoring
subscribers.