2-414
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
hccp channel-switch
Defaults
The CMTS is not configured to use a Cisco RF Switch by default, and no cable interfaces are configured
for N+1 redundancy by default.
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
You must configure each Working and Protect cable interface for use with the Cisco RF Switch, typically
specifying one
hccp channel-switch
command to configure the Cisco RF Switch information, and
another
hccp channel-switch
command to configure the upconverter.
The Protect interface is configured with the same
hccp channel-switch
commands as those that are used
on the Working interface. However, typically, the same Protect interface is configured with multiple
hccp channel-switch
commands to protect multiple Working interfaces.
console
(Optional) Specifies that the console port is being used to control the
Cisco RF Switch.
vty
(Optional) Specifies that a Virtual Terminal connection (Telnet connection)
is being used to control the Cisco RF Switch.
line-number
Specifies the line number on which the Cisco RF Switch is receiving control
information for this CMTS. The valid range is 0 to 17 for the default serial
port, 0 for the aux port, 0 for the console port, and 0 to 99 for the vty port.
port
Specifies the port number being used on the Cisco RF Switch. The valid
range is 1 to 255.
wavecom-hd
Specifies that this is the configuration for a VCom (Wavecom) HD4040 and
QHD4040 upconverter.
wavecom-ma
Specifies that this is the configuration for a VCom (Wavecom)
DUAL4040D, MA4040D, or UC4040D upconverter.
prot-ip-address
Specifies the IP address for the upconverter used for the Protect interface
used for this cable interface.
protect-module
Specifies the module number on the upconverter used for the Protect
interface to be used for this cable interface. The valid range is 1 to 255.
work-ip-address
Specifies the IP address for the upconverter used for the Working interface
used for this cable interface.
work-module
Specifies the module number on the upconverter used for the Working
interface to be used for this cable interface. The valid range is 1 to 255.
Release
Modification
12.2(4)XF1,
12.2(4)BC1
This command was introduced for the Cisco uBR10012 router, replacing
the
hccp ds-switch
command for use with the Cisco RF Switch.
12.2(8)BC2
Support was added for the Cisco uBR-LCP-MC16C, Cisco uBR-LCP-
MC16E, and Cisco uBR-LCP-MC16S cards on the Cisco uBR10012 router.
12.2(11)BC1
Support was added for the Cisco uBR7246VXR router and
Cisco uBR-MC16C, Cisco uBR-MC16S, and Cisco uBR-MC28C cards.