2-418
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
hccp ds-switch
hccp ds-switch
To specify the downstream upconverter module for a Working CMTS or Protect CMTS, use the
hccp ds-
switch
command in cable interface configuration mode. To negate a downstream upconverter
assignment, use the
no
form of this command.
hccp
group
ds-switch
member make host-ipaddr host-module peer-ipaddr peer-module
no hccp
group
ds-switch
member
Note
This command has been deprecated in current Cisco IOS releases and has been replaced by the
hccp
channel-switch
command.
Syntax Description
Defaults
Upconverter specification and activation is disabled by default and must be specified before switching
can take place.
Command Modes
Interface configuration (cable interface only)
Command History
group
The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
member
The member number within the specified group.
make
The maker of the specified upconverter. Currently, only the Wavecom
upconverter is supported (
wavecom
).
host-ipaddr
The IP address of the upconverter module
1
to which the host CMTS is
connected.
host-module
The upconverter module number to which the host CMTS is connected. This
location is expressed as a simple numeric designation.
peer-ipaddr
The IP address of the upconverter module to which the peer (or remote)
CMTS is connected.
peer-module
The upconverter module number
1
to which the peer (or remote) CMTS is
connected. This location is expressed as a simple numeric designation.
1.
The identification of the upconverter module is important to define when the host or peer CMTS is connected to a channel
switch housing multiple modules. For example, the Wavecom MA4040D upconverter chassis offers a maximum of 10
independent frequency agile upconverters.
Release
Modification
12.1(3a)EC
This command was introduced for the Cisco uBR7200 series routers.
12.1(7)EC1
Support was added for the Cisco uBR-MC16S cable interface line card.
12.2(4)XF1,
12.2(4)BC1
This command was deprecated and replaced by the
hccp channel-switch
command.