3-42
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable load-balance
show cable load-balance
To display real-time statistical and operational information for load-balancing operations on the router,
use the
show cable load-balance
command in privileged EXEC mode.
show cable load-balance
[
group
n
] [
all
|
load
|
pending
|
statistics
|
target
]
Syntax Description
Defaults
Displays information for all load-balance groups for each cable interface and its current load and load-
balancing status.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
Use the
show cable load-balance
command to display the current, real-time statistics for load-balancing
operations.
Examples
The following example shows typical output for the default display for the
show cable load-balance
command:
Router#
show cable load-balance
Interface State Group Utilization Reserved Modems Flows Weight
Cable6/1 (0 MHz) down 0 0%(0%/0%) 0% 0 0 27
Cable6/0 (0 MHz) initial 0 0%(0%/0%) 0% 0 0 27
Cable5/0 (0 MHz) down 0 0%(0%/0%) 0% 0 0 27
Cable4/1 (0 MHz) down 0 0%(0%/0%) 0% 0 0 27
Cable4/0 (0 MHz) down 0 0%(0%/0%) 0% 0 0 27
Cable3/1 (0 MHz) down 0 0%(0%/0%) 0% 0 0 27
Cable3/0 (0 MHz) up 0 0%(0%/0%) 0% 31 68 27
group
n
(Optional) Specifies the number of the load-balance group to be displayed.
The valid range is 1 to 20. The default is to display information for all load-
balance groups.
all
(Optional) Display all information listed below.
load
(Optional) Displays current interface load and load-balance group
assignments.
pending
(Optional) Displays list of cable modems that are currently being moved
from one downstream or upstream to another.
statistics
(Optional) Displays cumulative statistics for load-balancing operations.
target
(Optional) Displays the current and target interfaces (upstreams and
downstreams) that are being used for load balancing.
Release
Modification
12.2(15)BC1
This command was introduced for the Cisco uBR7246VXR and
Cisco uBR10012 routers.