3-81
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable modem cpe
show cable modem cpe
To display the CPE devices accessing the cable interface through a particular CM, use the
show cable
modem cpe
command in privileged EXEC mode.
show cable modem
{
ip-address
|
mac-address
}
cpe
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command lists the CPE devices that are accessing the cable network through a particular CM. You
can identify the CM either by its IP address or by its MAC address.
Note
Also see the information about this command’s behavior in a Hot Standby Connection-to-Connection
Protocol (HCCP) configuration, see the
“Operation with Hot Standby Connection-to-Connection
Protocol (HCCP) Configuration” section on page 3-54
.
Examples
The following example shows sample output for the
show cable modem cpe
command, listing the CPE
devices by their MAC and IP addresses:
Router#
show cable modem 10.14.1.20 cpe
IP address MAC address
10.14.30.100 00b0.4a9b.bc8c
10.14.30.101 00b0.4a9b.bc8d
Router#
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show
commands using the
exec prompt timestamp
command in line configuration mode.
ip-address
Displays the CPE devices for the CM with the specified IP address.
mac-address
Displays the CPE devices for the CM with the specified MAC address.
Release
Modification
11.3XA
This command was introduced.
12.1(4)CX and
12.2(4)BC1
The command was simplified to display only the IP and MAC addresses for
the CPE devices.
