3-199
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show hccp
Non Critical config
===================
int Cable6/0/0
!
end
Generic sub-interface master critical config
============================================
int Cable6/0/0
end
CMTS subinterface critical config
=================================
int Cable6/0/0
end
Non Critical config
===================
int Cable6/0/0
!
no ip address
no keepalive
end
Router#
The following shows a typical example of the show hccp command to display QoS parameters for a
particular member of a particular group:
Router#
show hccp 1 1 qosparam
Cable5/0/0:
Index Name Dir Sched Prio MaxSusRate MaxBurst MinRsvRate
1 US BE 0 64000 0 0
2 DS BE 0 1000000 0 0
3 US BE 7 1024000 1522 0
4 DS BE 0 10000000 1522 0
Router#
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show
commands using the
exec prompt timestamp
command in line configuration mode.
The following example shows a detailed display for the Cisco uBR-MC5X20S cable interface line card:
Router#
show hccp detail
mac-address 0005.00e4.1236
cmts config:
resolve sid, dci-response success,
downstream - frequency 441000000, channel id 0
downstream - insertion_invl auto min = 60, max = 480
downstream - rf-shutdown, rf-power 48
upstream 0 - frequency 11408000, power level 0
upstream 0 - modulation-profile 1, channel-width 3200000
upstream 0 - cnr-profile1 25, cnr-profile2 15
corr-fec 1, uncorr-fec 1
Note
For cable interfaces with an integrated upconverter, the line showing the RF power will show
rf-shutdown
when the upconverter has been powered off.
