3-208
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show interface cable
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show
commands using the
exec prompt timestamp
command in line configuration mode.
Related Commands
output errors
Sum of all errors that prevented the final transmission of packets
out of the interface being examined.
collisions
Not applicable.
interface resets
Number of times an interface has been completely reset.
output buffer failures
Number of times the output buffer has failed.
output buffer swapped out
Number of times the output buffer has been swapped out.
Table 3-50 show interface cable Field Descriptions (continued)
Field
Description
Command
Description
show interface cable
downstream
Displays information about the downstream on the cable interface.
show interface cable
sid
Displays information by service identifier (SID) of each CM on the network.
show interface cable
signal-quality
Displays information about the cable signal quality.
show interface cable
upstream
Displays information about one or all upstreams on the cable interface.