4-85
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
show pxf microcode
show pxf microcode
To display identifying information for the microcode being used on the Parallel eXpress Forwarding
(PXF) processor, use the
show pxf microcode
command in user EXEC or privileged EXEC mode.
show pxf microcode
Syntax Description
This command has no keywords or arguments.
Defaults
No default behavior or values
Command Modes
User EXEC, Privileged EXEC
Command History
Usage Guidelines
The PXF processors onboard the Performance Routing Engine (PRE1) module automatically load their
microcode at the same time that the Cisco IOS image is loaded into the PRE1 module. A fault situation
can cause one or both of the PXF processors to reload the microcode as needed. You can use the
show
pxf microcode
command to display the version of microcode currently loaded, as well as the number of
times the microcode has been loaded since the Cisco IOS software was loaded at system bootup.
Examples
The following example shows a typical display for the
show pxf microcode
command:
Router#
show pxf microcode
PXF complex: 2 Toasters 8 Columns total
Toaster processor tmc0 is running.
Toaster processor tmc1 is running.
Loaded microcode: system:pxf/u10k-1-ucode.2.3.1
Version: 2.3.1
Release Software created Wed 04-Sep-02 10:04
Signature: c99db74b91f8fae0a15e62e152c3f49f
Microcode load attempted 1 time(s), latest 3d17h ago
DISABLE_BOOTSTRAP_CLEAR
tmc0 FG_PC=1 BG_PC=5 WDog=1024 MinPhase=31
tmc1 FG_PC=1 BG_PC=5 WDog=1024 MinPhase=31
Cobalt Registers: 9 registers specified
00000064 0000000F 00000001
00000090 FFFF0000 FF000000
00000090 000003C0 00000000
00000090 00000003 00000002
00000094 FFFFFFFF AAAAAAAA
Release
Modification
12.2(4)XF1
This command was introduced as
show hardware pxf microcode
for the
Cisco uBR10012 router.
12.2(15)BC2
This command was renamed from
show hardware pxf microcode
to
show
pxf microcode
.
