4-92
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
show redundancy
PRE B (This PRE) : Primary
Uptime since this PRE switched to active : 5 minutes
Total system uptime from reload : 37 minutes
Switchovers this system has experienced : 5
Secondary failures since this PRE active : 0
The secondary PRE has been up for : 1 minute
The reason for last switchover: ACTIVE RP CRASHED
Secondary PRE information....
Secondary is up.
Secondary has 524288K bytes of memory.
Secondary BOOT variable = slot0:ubr10k-k8p6-mz.122-11.CY,12;
Secondary CONFIG_FILE variable = bootflash:030227.config
Secondary BOOTLDR variable =
Secondary Configuration register is 0x0
Secondary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Experimental Version 12.2(15)BC2
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 01-Mar-04 12:01 by anxrana
Primary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Released Version 12.2(15)BC2
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 01-Mar-04 12:01 by anxrana
Redundant RP last failure info as reported by Standby:
bus error at PC 0x605C8B24, address 0xFF012345
10000 Software (UBR10K-K8P6-M), Experimental Version 12.3(20040211:230003)
[narana-geo_cable 123]
Compiled Mon 01-Mar-04 12:01 by anxrana
Image text-base: 0x60008CB8, data-base: 0x61F80000
Stack trace from system failure:
FP: 0x7234C8C8, RA: 0x605C8B24
FP: 0x7234CA30, RA: 0x604940F4
FP: 0x7234CA90, RA: 0x60151FF0
FP: 0x7234CAB0, RA: 0x604A5554
FP: 0x7234CB40, RA: 0x6051F638
FP: 0x7234CB58, RA: 0x6051F61C
Router#
The following example shows a typical display from the
show redundancy
command in Cisco IOS
Release 12.2(15)BC1 and earlier releases. The active PRE1 module is in PRE slot A, and the standby
PRE1 module is in PRE slot B:
Router#
show redundancy
PRE A (This PRE) : Primary
PRE B : Secondary
Redundancy state is REDUNDANCY_PEERSECONDARY_INITED
Secondary PRE information....
Secondary is up.
Secondary has 524288K bytes of memory.
Secondary BOOT variable = bootflash:ubr10k-k8p6-mz
Secondary CONFIG_FILE variable =