4-93
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
show redundancy
Secondary BOOTLDR variable = bootflash:c10k-eboot-mz
Secondary Configuration register is 0x2102
Secondary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Released Version 12.2(11)BC3
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 03-Mar-03 11:28 by texbnt
Router#
The following example shows the same display but after a switchover has occurred. The
show
redundancy
command now shows that the active (primary) PRE has changed slots (in this case, moving
from slot A to slot B):
Router#
show redundancy
PRE A : Secondary
PRE B (This PRE) : Primary
Redundancy state is REDUNDANCY_PEERSECONDARY_INITED
Secondary PRE information....
Secondary is up.
Secondary BOOT variable = bootflash:ubr10k-k8p6-mz
Secondary CONFIG_FILE variable =
Secondary BOOTLDR variable = bootflash:c10k-eboot-mz
Secondary Configuration register is 0x2
Secondary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Released Version 12.2(13)BC2
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled 26 08-Feb-03 11:28 by texbnt
Router#
The following example shows a typical display when the standby PRE1 module is not installed or is not
operational. The standby (secondary) PRE1 module is shown as not up, and its boot variables and
configuration register are not shown.
Router#
show redundancy
PRE A (This PRE) : Primary
PRE B : Secondary
Redundancy state is REDUNDANCY_PEERSECONDARY_NONOPERATIONAL
Secondary PRE information....
Secondary PRE is not up
Router#
Clients Display
The following example shows a typical display for the
show redundancy clients
command:
Router#
show redundancy clients
clientID = 0 clientSeq = 0 RF_INTERNAL_MSG
clientID = 25 clientSeq = 130 CHKPT RF
clientID = 5 clientSeq = 170 RFS client
clientID = 50 clientSeq = 530 Slot RF
clientID = 65000 clientSeq = 65000 RF_LAST_CLIENT