5-14
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug cable config-file
debug cable config-file
To display information about the DOCSIS configuration files that are generated by the internal DOCSIS
configuration file editor, use the
debug cable config-file
command in Privileged EXEC mode. To disable
debugging output, use the
no
form of this command.
debug cable config-file
no debug cable config-file
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command shows debugging messages about the internal configuration file editor on the Cisco
CMTS. For more information about the internal configuration file editor, see the
cable config-file
command and its subcommands.
Caution
The debug commands are primarily intended for use in controlled test and troubleshooting situations
with a limited volume of traffic.
Examples
The following example shows how to enable debugging for the internal configuration file editor:
Router#
debug cable config-file
CMTS config file debugging is on
Router#
show debug
CMTS:
CMTS config file debugging is on
Router#
When debugging is turned on, the Cisco CMTS displays the following message when it generates a
DOCSIS configuration file for transmission to a CM:
Release
Modification
12.1(2)EC
This command was introduced for Cisco uBR7200 series routers.
12.1(5)EC
Support for this command was added for the Cisco uBR7100 series
routers.
12.2(4)BC1
Support was added to the Release 12.2 BC train.
12.2(11)BC2
Support for this command was added to the Release 12.2 BC train.
