3
Catalyst 2955 Switch DIN Rail Clip Installation Notes
OL-5262-01
Mounting the Switch on a DIN Rail
Figure 2
DIN Rail Clip Face-Down Mounting Configuration
Warning
This equipment is supplied as “open type” equipment. It must be mounted within an enclosure that is
suitably designed for those specific environmental conditions that will be present and appropriately
designed to prevent personal injury resulting from accessibility to live parts. The interior of the
enclosure must be accessible only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards.
Caution
To prevent the switch from overheating, there must be a minimum of 3 inches between any other device
and the top, bottom, or sides of the switch.
1
Catalyst 2955 switch top panel
3
DIN rail clip mounting screws
2
DIN rail clip assembly
104561
2
1
3
