29-6
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 29 Configuring SPAN and RSPAN
Understanding SPAN and RSPAN
•
The switch does not support a combination of local SPAN and RSPAN in a single session.
–
An RSPAN source session cannot have a local destination port.
–
An RSPAN destination session cannot have a local source port.
–
An RSPAN destination session and an RSPAN source session that are using the same RSPAN
VLAN cannot run on the same switch or switch stack.
Monitored Traffic
SPAN sessions can monitor these traffic types:
•
Receive (Rx) SPAN—The goal of receive (or ingress) SPAN is to monitor as much as possible all
the packets received by the source interface or VLAN before any modification or processing is
performed by the switch. A copy of each packet received by the source is sent to the destination port
for that SPAN session.
Packets that are modified because of routing or quality of service (QoS)—for example, modified
Differentiated Services Code Point (DSCP)—are copied before modification.
Features that can cause a packet to be dropped during receive processing have no effect on ingress
SPAN; the destination port receives a copy of the packet even if the actual incoming packet is
dropped. These features include IP standard and extended input access control lists (ACLs), ingress
QoS policing, VLAN ACLs, and egress QoS policing.
•
Transmit (Tx) SPAN—The goal of transmit (or egress) SPAN is to monitor as much as possible all
the packets sent by the source interface after all modification and processing is performed by the
switch. A copy of each packet sent by the source is sent to the destination port for that SPAN session.
The copy is provided after the packet is modified.
Packets that are modified because of routing—for example, with modified time-to-live (TTL),
MAC-address, or QoS values—are duplicated (with the modifications) at the destination port.
Features that can cause a packet to be dropped during transmit processing also affect the duplicated
copy for SPAN. These features include IP standard and extended output ACLs and egress QoS
policing.
•
Both—In a SPAN session, you can also monitor a port or VLAN for both received and sent packets.
This is the default.
The default configuration for local SPAN session ports is to send all packets untagged. SPAN also does
not normally monitor bridge protocol data unit (BPDU) packets and Layer 2 protocols, such as Cisco
Discovery Protocol (CDP), VLAN Trunk Protocol (VTP), Dynamic Trunking Protocol (DTP), Spanning
Tree Protocol (STP), and Port Aggregation Protocol (PAgP). However, when you enter the
encapsulation replicate keywords when configuring a destination port, these changes occur:
•
Packets are sent on the destination port with the same encapsulation—untagged, Inter-Switch Link
(ISL), or IEEE 802.1Q—that they had on the source port.
•
Packets of all types, including BPDU and Layer 2 protocol packets, are monitored.
Therefore, a local SPAN session with encapsulation replicate enabled can have a mixture of untagged,
ISL, and IEEE 802.1Q tagged packets appear on the destination port.