38-27
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 38 Configuring IP Unicast Routing
Configuring OSPF
Table 38-5
Default OSPF Configuration
Feature
Default Setting
Interface parameters
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Area
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
Auto cost
100 Mb/s.
Default-information originate
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Default metric
Built-in, automatic metric translation, as appropriate for each
routing protocol.
Distance OSPF
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
OSPF database filter
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
IP OSPF name lookup
Disabled.
Log adjacency changes
Enabled.
Neighbor
None specified.
Neighbor database filter
Disabled. All outgoing LSAs are flooded to the neighbor.
Network area
Disabled.
NSF
1
awareness
Enabled
2
. Allows Layer 3 switches to continue forwarding
packets from a neighboring NSF-capable router during hardware
or software changes.
NSF capability
Disabled.
Note
The switch stack supports OSPF NSF-capable routing
for IPv4.
Router ID
No OSPF routing process defined.
Summary address
Disabled.
