38-38
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 38 Configuring IP Unicast Routing
Configuring EIGRP
•
Configuring EIGRP Route Authentication, page 38-42
•
EIGRP Stub Routing, page 38-43
•
Monitoring and Maintaining EIGRP, page 38-44
Note
To enable EIGRP, the switch or stack master must be running the IP services feature set.
Default EIGRP Configuration
Table 38-7
shows the default EIGRP configuration.
Table 38-7
Default EIGRP Configuration
Feature
Default Setting
Auto summary
Enabled. Subprefixes are summarized to the classful network
boundary when crossing classful network boundaries.
Default-information
Exterior routes are accepted and default information is passed
between EIGRP processes when doing redistribution.
Default metric
Only connected routes and interface static routes can be redistributed
without a default metric. The metric includes:
•
Bandwidth: 0 or greater kb/s.
•
Delay (tens of microseconds): 0 or any positive number that is a
multiple of 39.1 nanoseconds.
•
Reliability: any number between 0 and 255 (255 means
100 percent reliability).
•
Loading: effective bandwidth as a number between 0 and 255
(255 is 100 percent loading).
•
MTU: maximum transmission unit size of the route in bytes. 0 or
any positive integer.
Distance
Internal distance: 90.
External distance: 170.
EIGRP log-neighbor changes
Disabled. No adjacency changes logged.
IP authentication key-chain
No authentication provided.
IP authentication mode
No authentication provided.
IP bandwidth-percent
50 percent.
IP hello interval
For low-speed nonbroadcast multiaccess (NBMA) networks:
60 seconds; all other networks: 5 seconds.
IP hold-time
For low-speed NBMA networks: 180 seconds; all other networks:
15 seconds.
IP split-horizon
Enabled.
IP summary address
No summary aggregate addresses are predefined.
Metric weights
tos: 0; k1 and k3: 1; k2, k4, and k5: 0
Network
None specified.
