41-11
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 41 Configuring Cisco IOS IP SLAs Operations
Configuring IP SLAs Operations
To disable the IP SLAs operation, enter the no ip sla operation-number global configuration command.
This example shows how to configure a UDP jitter IP SLAs operation:
Switch(config)#
ip sla 10
Switch(config-ip-sla)#
udp-jitter 172.29.139.134 5000
Switch(config-ip-sla-jitter)#
frequency 30
Switch(config-ip-sla-jitter)#
exit
Switch(config)#
ip sla schedule 5 start-time now life forever
Switch(config)#
end
Switch#
show ip sla configuration 10
IP SLAs, Infrastructure Engine-II.
Entry number: 10
Owner:
Tag:
Type of operation to perform: udp-jitter
Target address/Source address: 1.1.1.1/0.0.0.0
Target port/Source port: 2/0
Request size (ARR data portion): 32
Operation timeout (milliseconds): 5000
Packet Interval (milliseconds)/Number of packets: 20/10
Type Of Service parameters: 0x0
Verify data: No
Vrf Name:
Control Packets: enabled
Schedule:
Operation frequency (seconds): 30
Next Scheduled Start Time: Pending trigger
Group Scheduled : FALSE
Randomly Scheduled : FALSE
Life (seconds): 3600
Entry Ageout (seconds): never
Recurring (Starting Everyday): FALSE
Status of entry (SNMP RowStatus): notInService
Threshold (milliseconds): 5000
Distribution Statistics:
Number of statistic hours kept: 2
Number of statistic distribution buckets kept: 1
Statistic distribution interval (milliseconds): 20
Enhanced History:
Analyzing IP Service Levels by Using the ICMP Echo Operation
The ICMP echo operation measures end-to-end response time between a Cisco device and any devices
using IP. Response time is computed by measuring the time taken between sending an ICMP echo
request message to the destination and receiving an ICMP echo reply. Many customers use IP SLAs
ICMP-based operations, in-house ping testing, or ping-based dedicated probes for response time
measurements between the source IP SLAs device and the destination IP device. The IP SLAs ICMP
echo operation conforms to the same specifications as ICMP ping testing, and the two methods result in
the same response times.
Step 7
end
Return to privileged EXEC mode.
Step 8
show ip sla configuration
[operation-number]
(Optional) Display configuration values, including all defaults for all IP SLAs
operations or a specified operation.
Step 9
copy running-config
startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
