Description
Port
The Supervisor Card has one mini type-B USB
console port. This port is an asynchronous
EIA/TIA-232 serial port used to connect a terminal
to the Supervisor Card for local administrative access.
Console port
The ports on the Supervisor Card are used for temporary connections. For all permanent connections, including
the console connection, you must use the ports on the Supervisor PIC installed in the rear of the chassis.
Note
The Supervisor Card has the following LEDs:
Description
LED
Power status LED
PWR STAT
RP status LED
RP STAT
RP active LED
RP ACT
FP status LED
FP STAT
FP active LED
FP ACT
iNSI active LED
INSI ACT
Alarm LED
ALRM
Replace LED
RPLC
Different Supervisor Cards cannot coexist on a Cisco cBR-8 router. We recommend that you install the
Supervisor Cards with the same capacity in the chassis to ensure proper redundancy support.
Important
Supervisor PIC
The Supervisor PIC provides the physical interface to the Supervisor Card. It is installed in the rear of the
Cisco cBR chassis.
Cisco Converged Broadband Routers Hardware Installation Guide
22
What is a Cisco cBR Series Converged Broadband Router
Cisco cBR-8 Converged Cable Access Router Supervisor 250G