Depending on the size of the installation and the number and type of cables being used, the body of the
chassis may become overcrowded and unable to accommodate all the required cables. To resolve this
issue, you can install two pass-through accessory plates to allow cables be guided outside the vertical
trough.
Note
Installing the Cable Pass-through Accessory Plates (Optional)
Step 5
Remove the blank plates by unscrewing the four screws on each one.
Step 6
Attach the inner cut-out panels using the four screws provided.
Figure 97: Cut-out plate
Step 7
Attach the outer cut-out panel using the four screws provided.
Installing the Upper Grille and Logo Bezel
Step 8
Attach the upper grille (optional) by carefully inserting the tabs on the grille into the hook hanger brackets on the top
of the upper grille support (see next figure).
Step 9
Press the grille firmly against the grille support until it snaps onto the ball stud snaps.
If you attach the upper grille, you must have the power shutoff extenders installed (fixed configuration power
only-Step 3).
Note
Step 10
Place the logo bezel (see the next figure) over the bezel support, and press firmly until the bezel snaps onto the ball
stud snaps.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
179
Installing and Removing Exterior Cosmetic Components
Steps