4-56
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-10
Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Steps
To remove a bale-clasp SFP module from a PLIM, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2
Disconnect and remove all interface cables from the ports. Be sure to note the current connections of the
cables to the ports on the PLIM.
Step 3
Open the bale-clasp on the module with your index finger in a downward direction (see
Figure 4-35
). If
the bale-clasp is obstructed and you cannot use your index finger to open it, use a small screwdriver or
other long, narrow instrument to open the bale-clasp.
Step 4
Grasp the module between your thumb and index finger and carefully remove it from the port (see
Figure 4-35
).
Note
Be careful to hold the module in such a way so as to not damage the bale-clasp.