5-4
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-10
Chapter 5 Installing and Removing the Doors and Grille
Installing the Doors
Steps
To remove the inlet grille, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the front side or a bare metal surface on the chassis.
Step 2
If the doors have been installed, open the doors to get complete access to the grille.
Step 3
Using the Number 2 flat-blade screwdriver, unscrew the two captured screws at the upper right and left
corners of the grille.
Step 4
Firmly grasp the outside edges of the inlet grille.
Step 5
Pull the bottom of the grille firmly away from the chassis; it loosens from the connecting ball studs.
Step 6
Carefully set the inlet grille aside.
Installing the Doors
This section describes how to install the doors on the Cisco CRS 4-slot chassis. We recommend that you
install the doors when the chassis has been mounted into its rack.
Prerequisites
Before you install the doors on the Cisco CRS 4-slot chassis, you must install the grille as described
above.
Required Tools and Equipment
You need the following tool and parts to perform this task:
•
ESD-preventive wrist strap
•
Left and right doors (Cisco product number: CRS-4-DOOR-KIT)
Steps
To install the doors on the Cisco CRS 4-slot chassis, follow these steps:
Step 1
Remove the door from its packaging (including the protective film that covers each door), and set the
packaging aside.
Step 2
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
or a bare metal surface on the chassis.
Step 3
Starting with the left door, align the bottom guide pin over the hole in the lower door mounting bracket
(see
Figure 5-3
).
Step 4
Drop the door’s bottom guide pin into the lower door mounting bracket hole (see
Figure 5-3
).
