Purpose
Command or Action
Enters RSVP interface authentication configuration mode.
authentication
Example:
RP/0/RP0/CPU0:router(config-rsvp-if)#
Step 3
authentication
RP/0/RP0/CPU0:router(config-rsvp-if-auth)#
Specifies the maximum number of RSVP authenticated messages
that can be received out-of-sequence.
window-size N
Example:
RP/0/RP0/CPU0:router(config-rsvp-if-auth)#
Step 4
N
Size of the window to restrict out-of-sequence messages. The
range is from 1 to 64. The default value is 1, in which case
all out-of-sequence messages are dropped.
window-size 33
commit
—
Saves the configuration changes and remains within the
configuration session.
Use the
commit
or
end
command.
Step 5
end
—
Prompts user to take one of these actions:
•
Yes
—
Saves configuration changes and exits the configuration
session.
•
No
—
Exits the configuration session without committing the
configuration changes.
•
Cancel
—
Remains in the configuration session, without
committing the configuration changes.
Related Topics
Guidelines for Window-Size and Out-of-Sequence Messages, on page 122
RSVP Authentication by Using All the Modes: Example, on page 152
RSVP Authentication for an Interface: Example, on page 151
Configuring RSVP Neighbor Authentication
These tasks describe how to configure the RSVP neighbor authentication:
•
Specifying the Keychain for RSVP Neighbor Authentication, on page 142
•
Configuring a Lifetime for RSVP Neighbor Authentication, on page 143
•
Configuring the Window Size for RSVP Neighbor Authentication, on page 144
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
141
Implementing RSVP for MPLS-TE and MPLS O-UNI
Configuring RSVP Neighbor Authentication