Configuring LDP Link: Example
The example shows how to configure LDP link parameters.
mpls ldp
interface pos 0/1/0/0
!
!
show mpls ldp discovery
Related Topics
Configuring LDP Discovery Over a Link, on page 27
LDP Control Plane, on page 7
Configuring LDP Discovery for Targeted Hellos: Example
The examples show how to configure LDP Discovery to accept targeted hello messages.
Active (tunnel head)
mpls ldp
router-id 192.168.70.1
interface tunnel-te 12001
!
!
Passive (tunnel tail)
mpls ldp
router-id 192.168.70.2
discovery targeted-hello accept
!
Related Topics
Configuring LDP Discovery for Active Targeted Hellos, on page 29
Configuring LDP Discovery for Passive Targeted Hellos, on page 32
LDP Control Plane, on page 7
Configuring Label Advertisement (Outbound Filtering): Example
The example shows how to configure LDP label advertisement control.
mpls ldp
address-family ipv4
label local advertise
disable
for pfx_acl_1 to peer_acl_1
for pfx_acl_2 to peer_acl_2
for pfx_acl_3
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
80
Implementing MPLS Label Distribution Protocol
Configuring LDP Link: Example