C-14
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Appendix C Command Reference
Commands
You can also use the
set time
command to enable an NTP server to synchronize the ACS SE. You can
configure one or more NTP servers by separating each NTP IP address entry with a space. For more
information, see
Setting the System Time and Date with NTP, page 4-20
and the command reference
ntpsync, page C-7
.
Example
The following command initiates the system time setting procedure:
set time
set timeout
To set the period, in minutes, after which the serial console will time out, use the
set timeout
command:
set timeout
[
minutes
]
Syntax Description
This command has a single argument: the number of minutes before timing out. If you enter the
command with no argument, the system prompts you for a value in minutes.
Example
The following command establishes a serial console timeout after10 minutes:
set timeout
10
show
To show the version of the ACS SE, system load status, ACS service status, IP configuration, system
time, and NTP settings, ACS SE hostname, DNS domain, and timeout value, use the
show
command:
show
Syntax Description
This command has no arguments or keywords.
Example
The following command lists ACS SE information:
show
shutdown
To shut down the appliance from the serial console, use the
shutdown
command:
shutdown
Syntax Description
This command has no arguments or keywords.
