3-17
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
Step 6
At the
Enter new password again:
prompt, enter the new password again, and press
Enter
.
Result
: The console displays:
GUI Administrator added successfully.
Note
The new GUI administrator account is not usable until you unlock it by entering the
unlock guiadmin
command.
Now, you can now use the GUI administrator account to remotely access the ACS GUI running on the
ACS SE.
Next Steps
After you have successfully performed the procedures in this guide, your ACS SE is installed and
initially configured. The next step is to log in using the GUI administrator account and use a browser
and the web interface to fully configure your ACS SE to provide the AAA services that you want from
this installation. The HTML address is in the following format: http://<
ip address
>:2002, where
ip
address
is the address that you assign during configuration.
For information on setting up user, group, network, and other parameters, see the
User Guide for Cisco
Secure ACS
.
Note
The ACS Solution Engine automatically creates an entry called
Self
in the AAA Servers Table. This entry
identifies the Solution Engine machine.
However, in the Proxy Distribution Table and the AAA Server Table for RDMS synchronization, the
ACS Solution Engine creates an entry for the hostname of the device that is running the ACS Solution
Engine.
