4-12
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 4 Administering Cisco Secure ACS Solution Engine
Working with System Data
Exporting a List of Users
This section details the procedure for exporting a list of ACS SE users to an FTP server for further
examination and processing.
Before You Begin
You must have the FTP server address and pathname, as well as the proper credentials for writing to the
FTP server (username and password).
Caution
Performing this procedure stops and restarts the
CSAuth
service, and will interrupt use of the ACS SE.
To export a list of users to an FTP server:
Step 1
Log in to the ACS SE. For more information, see
Logging In to the Solution Engine From a Serial
Console, page 4-2
.
Step 2
Type
exportusers
.
Tip
You can enter the following parameters after the command or in response to subsequent prompts:
[server] [username] [filepath]
Step 3
Press
Enter
.
Result
: The system displays the message:
Command with restart CSAuth. Are you sure you want to continue?
Caution
Performing this procedure stops and restarts the
CSAuth
service, and will interrupt use of the ACS SE.
Step 4
To proceed, type
Y
and press
Enter
.
Step 5
At the
Enter FTP Server Hostname or IP Address
prompt, enter the FTP server IP address or
hostname and press
Enter
.
Step 6
At the
Directory:
prompt, enter the FTP server pathname and press
Enter
.
Step 7
At the
Username:
prompt, enter your FTP server username and press
Enter
.
Step 8
At the
Password:
prompt, enter your FTP server password and press
Enter
.
Result
: ACS SE exports the file of the list of users to the specified location, and then displays the
message:
Transferring ‘users.txt’ completed
The system prompt reappears.
Backing Up ACS Data From the Serial Console
This section details how to use the serial console to back up ACS SE data to an FTP server.
