Chapter 5 Web GUI Setup and Monitoring
256
Adding a Trap Destination
1
Click
Add
in the Trap Destination Configuration area.
2
In the
Trap Destination IP Address
field, enter the IP address that sets the
destination for SNMP trap messages for system events (for example, fault
messages).
3
In the Community String field, enter the community string for the trap
destination (IP address entered above).
Enter public or custom string. The default is public. You can enter a string up to
35 characters.
4
Click
Apply
.
To edit/delete an existing trap destination, select the trap destination entry by
clicking on the radio button. Click
Edit
and make the necessary changes, or click
Delete
to remove the address from the Trap Destination Configuration list.
Summary of Contents for D9824
