4011350 Rev D
129
How Do I Configure the Wireless Home Gateway?
Setup Wireless - Access Control Page Description
This section describes the section headings and field descriptions of the Setup
Wireless - Access Control page.
Field Name
Description
Access restriction
When encryption is enabled, this selection allows you to
choose one of the following options from the drop-down
list:
Disable (factory default)–No access restrictions based
on MAC address of wireless access devices
Allow–Allows wireless access to only the MAC
addresses listed in the Access List
Deny–Denies wireless access to only the MAC
address listed in the Access List
Closed Network
Allows you to disable or enable the network to access by
wireless clients. When
ON
is selected, the access point
does not broadcast the SSID. The client device must be
configured manually with the SSID and the MAC address
of the access point in order to access with wireless
network.
Access List
Displays the MAC address of the clients that are subject
to wireless access control
Connected Clients
Displays the Host Name, IP Address, and Client ID of
wireless clients that are connected to (associated with) the
gateway modem
Function Keys
The following function keys appear on the Setup Wireless – Access Control page.
Key
Description
Apply
Applies and saves the values you enter into the fields
without closing the screen
Clear All
Clears the Access List
Remove
Removes entries from the Access List
Add
Adds a client to the Access List using the MAC address of
the client