Chapter 2 Installing the DOCSIS Wireless Residential Voice Gateway
16
OL-30505-01
WARNING:
Fully charged high-capacity rechargeable batteries should be handled with
care. Replace only with the battery recommended by the manufacturer. Do not
disassemble it or attempt to recharge the battery outside the system. Do not
crush, puncture, dispose of in a fire, short the external contacts, or expose to
high temperature or immerse in water or other liquids. Dispose of the battery
in accordance with local regulations and instructions from your service
provider
.
1
Turn the residential gateway so that you are facing the side with the battery
compartment.
2
Gently release the latch to open the battery cover and gain access to the battery
compartment.
3
Insert the battery into the battery compartment. Do not force the battery into the
compartment, but be sure to press the battery all the way in until it seats fully.
<Insert battery bottom panel>
4
Close the battery compartment door.
Important:
After you install the residential gateway and plug it into an AC
electrical outlet as described in
Install the Wireless Residential Voice Gateway
(on page 17), it can take as long as 24 hours for the battery to charge fully.
However, you can begin using your high-speed Internet and telephone service
immediately after installation. See
Normal Operations (AC Power Applied)
(on
page 22) for information on how the LEDs on the front of the residential gateway
indicate the state of the battery charge.
