Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
Prerequisites for Cisco G.SHDSL EFM/ATM EHWICs
2
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
•
Firmware Update, page 45
•
Command Reference, page 49
•
Additional References, page 81
Prerequisites for
Cisco G.SHDSL EFM/ATM EHWICs
•
Ensure that you have the appropriate Cisco router to serve as the host router.
The following Cisco routers support Cisco G.SHDSL EFM/ATM EHWICs:
–
Cisco 1921 ISR
–
Cisco 1941 ISR
–
Cisco 2901 ISR
–
Cisco 2911 ISR
–
Cisco 2921 ISR
–
Cisco 2951 ISR
–
Cisco 3925 ISR
–
Cisco 3925-E ISR
–
Cisco 3945 ISR
–
Cisco 3945-E ISR
•
Use the
show version
command to ensure that the router is running the correct IOS software. The
C888EA and EHWIC-4SHDSL-EA models require Cisco IOS Release Release: <optional, example:
Cisco IOS Release 15.1(1)T> or later.
Note
When minimum release requirements are met, you can change images on the router without
affecting performance.
•
Install the Cisco G.SHDSL EFM/ATM EHWIC on the router, using the directions provided in
Cisco
Interface Cards Hardware Installation Guide
and
Cisco Network Modules and Interface Cards
Regulatory Compliance and Safety Information
.
Information About Cisco G.SHDSL EFM/ATM
Cisco G.SHDSL EFM/ATM EHWICs support up to four pairs of digital subscriber lines (DSL). The
fixed platform model (C888EA) also supports up to four pairs. The DSL pairs are bundled in groups and
configured in the Cisco IOS command-line interface (CLI) by using the
dsl-group
command. Selecting
the mode is done by using the
mode
command.
See the
“Command Reference” section on page 49
for more information about commands used with
Cisco G.SHDSL EFM/ATM.
