Connecting Cisco Analog Video Gateway Network Modules to the Network
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
8
Connecting Cisco Analog Video Gateway Network Modules to the Network
Connecting the EVM-IPVS-16A Network Module to the Network
This section describes how to connect the EVM-IPVS-16A network module to devices in the video
surveillance network.
Note
If an installation technician has already connected the EVM-IPVS-16A to the devices in your network,
then do not perform this task. Instead, proceed directly to the software configuration for your
EVM-IPVS-16A network module. See the
Cisco Analog Video Gateway 1.0 Installation and Upgrade
Guide
at:
http://www.cisco.com/en/US/docs/video/cavg/cavginstall/cavginstall.html
Prerequisites
•
Install the EVM-IPVS-16A network module in the router chassis. See the
Installing Cisco Network
Modules in Cisco Access Routers
guide at:
http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNe
tM.html
•
Wire the provided terminal block connectors. See the
“Wiring the Terminal Block Connectors”
section on page 6
.
Steps
To connect the EVM-IPVS-16A network module to the network, follow these steps:
Step 1
Take the DB-37 end of the provided DB-37 to BNC video breakout cable, and connect it to the VIDEO
connector on the EVM-IPVS-16A network module.
