Introduction
About This Document
This document describes how to install a Cisco Expressway appliance into your video network. It contains information
on:
■
Preparing the installation.
■
Installing the hardware.
■
Performing the initial configuration.
■
Troubleshooting the installation.
About the Cisco Expressway Appliance
The Cisco Expressway appliance described in this document is a CE1100, which is based on a UCS C220 M4L. For
more detailed information on installing this appliance, see the
Cisco UCS C220 Server Installation and Service Guide
.
The appliance ships with the Cisco Expressway software pre-installed, and you can upgrade the software if
necessary.
The appliance supports Cisco Expressway version X8.6.1 or later.
Note:
If you choose to use the copper SFPs, the unit cannot support more than 150 traversal calls. This is the case
even if the option key for extra traversal calls has been installed.
Item
Part
Quantity
Chassis
UCS-C220-M4L
1
Processor
UCS-CPU-E52637D (3.5 GHz/ 4 core - hyper threaded)
2
RAM
UCS-MR-1X162RU-A (16GB)
2
Hard Disk
UCS-HD2T7KL12G
2
Onboard SAS Controller
UCSC-MRAID12G (Cisco 12G SAS Modular Raid Controller, 1 GB
cache and SuperCap)
1
NIC
N2XX-AIPCI01 (Intel X520 Dual Port 10Gb SFP+ Adapter)
1
EXP-10GSFP-SR (10Gb SR Fiber SFP)
2
EXP-1GSFP-T (1Gb Copper SFP)
2
PSU
UCSC-PSU1-770W & power cable
2
TPM
UCSX-TPM2-001 (Trusted Platform Module)
1
SD Card
UCS-SD-32G-S (32GB SD Card for UCS servers)
1
Miscellaneous
UCSC-RAILF-M4 (Rail kit)
1
UCSC-HS-C220M4 (Heat sink)
2
UCSC-MLOM-BLK (MLOM blank panel)
1
UCSC-BBLKD-L (3.5-inch HDD blank panel)
2
Table 2 Components for this Appliance
5
Cisco Expressway CE1100 Appliance Installation Guide
Introduction
