connect vdp
To connect to the Radware DefensePro (vDP) CLI, use the
connect vdp
command.
connect vdp
[
name
]
Syntax Description
(Optional) Specifies the vDP application instance name, which is the same as
the main application logical device/application instance name.
name
Command Modes
connect module/
Command History
Modification
Release
Added the
name
argument.
2.4(1)
Command added.
1.1(4)
Usage Guidelines
See the vDP documentation for commands available from the CLI.
To exit the vDP console, enter
Ctrl-], .
Return to the supervisor level of the FXOS CLI:
Exit the console:
Enter
~
, then
quit
to exit the Telnet application.
Example:
>
Ctrl-], .
Firepower-module1>
~
telnet>
quit
firepower#
Exit the Telnet session:
Enter
Ctrl-], .
Example:
>
Ctrl-], .
Firepower-module1>
Ctrl-], .
firepower#
Example
This example shows how to connect to the vDP CLI on module 1:
firepower# connect module 1 console
Telnet escape character is '~'.
Trying 127.5.1.1...
Connected to 127.5.1.1.
Cisco Firepower 4100/9300 FXOS Command Reference
50
A – R Commands
connect vdp
Summary of Contents for Firepower 4100 Series
