Command History
The CLI stores all commands used in the current session. You can step through the previously used commands
by using the up-arrow or down-arrow keys. The up-arrow key moves to the previous command in the history,
and the down-arrow key moves to the next command in the history. When you get to the end of the history,
pressing the down-arrow key does nothing.
You can enter any command in the history again by stepping through the history to recall that command and
then pressing
Enter
. The command is entered as if you had manually typed it. You can also recall a command
and change it before you press
Enter
.
Cisco Firepower 4100/9300 FXOS Command Reference
9
CLI Overview
Command History
Summary of Contents for Firepower 4100 Series
