Table 2: 40-Gb BASE-SR Cable Specifications
Supported Cable
Interface
50 microns core diameter
Ethernet 40-G BASE-SR4
2000/4700 (OM3/4) modal bandwidth (MHz*km)
850 nm wavelength
50 m cable distance
MPO-12 port adapter
See the
Cisco 40GBASE QSFP Modules Data Sheet
for specifications of the QSFP for the 40-Gb BASE-SR-4.
Note
We recommend the following Cisco OM3 MTP/MPO cables.
Table 3: Cisco Cables
Cable Length
Cisco Part Number
5 m
CAB-ETH-40G-5M
10 m
CAB-ETH-40G-10M
20 m
CAB-ETH-40G-20M
1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass
The following figure shows the front panel of the 1-Gb SX, 10-Gb SR and 10-Gb LR hardware bypass network
modules (FPR4K-NM-6X1SX-F, FPR4K-NM-6X10SR-F, FPR4K-NM-6X10LR-F). This is a single-wide
module that does
not
support hot swapping. The six ports are numbered from top to bottom, left to right. Pair
ports 1 and 2, 3 and 4, and 5 and 6 to form hardware bypass paired sets.
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
Cisco Firepower 4100/9300 FXOS Firmware Upgrade Guide
. See
for the software compatibility matrix.
Note
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
18
Overview
1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass