![background image](http://html.mh-extra.com/html/cisco/gigabit-switch-router-cisco-12012/gigabit-switch-router-cisco-12012_installation-and-configuration-manual_65984213.webp)
C H A P T E R
Troubleshooting the Installation 5-1
5
Troubleshooting the Installation
Your Cisco 12012 went through extensive testing and burn-in before leaving the factory.
However, if you encounter problems starting up the router, use the information in this
chapter to help isolate the cause of the problems.
This chapter contains the following sections:
•
Troubleshooting Overview
•
Troubleshooting the Power Subsystem
•
Troubleshooting the Processor Subsystem
•
Troubleshooting the Cooling Subsystem
•
Additional Reference Information for Troubleshooting
The procedures in this chapter assume that you are troubleshooting the initial Cisco 12012
system startup, and that the system is in the original factory configuration. If you have
removed or replaced components or changed any default settings, the recommendations in
this chapter might not apply.
At the initial system boot, you should verify the following:
•
External power cables are connected, and proper source power is being supplied.
•
The system blower modules are operating.
•
The Cisco IOS software boots successfully.
•
The RP and line cards are properly installed in their slots, and each initializes (is enabled
by the system software) without problems.
Summary of Contents for Gigabit Switch Router Cisco 12012
