![background image](http://html.mh-extra.com/html/cisco/gigabit-switch-router-cisco-12012/gigabit-switch-router-cisco-12012_installation-and-configuration-manual_65984234.webp)
6-4 Cisco 12012 Gigabit Switch Router Installation and Configuration Guide
Diagnostic Testing Sequence
Diagnostic Testing Sequence
When testing a card, the diagnostics perform the following operations in this sequence:
1
Halts the normal operation of the card.
The card is no longer available for network traffic.
2
Downloads a diagnostic image from the RPs running IOS software to the line card
before testing.
The Cisco IOS software image is removed from the line card DRAM and is replaced
with the diagnostic software image for the duration of the tests.
3
Sends and receives messages across the MBus to and from the card being tested.
During the testing process, messages are passed from the line card under test to the RP.
If the verbose option is turned on, interim messages listing the start and completion of
each test are displayed at the console. If the verbose option is not specified (default), the
console displays the minimum number of messages.
4
Displays pass or fail test results.
At the conclusion of the diagnostic tests, a pass or fail message is sent to the RP, which
passes the message to the console and to the alphanumeric LED display on the line card
being tested. The message is displayed on the alphanumeric display until the Cisco IOS
image is booted following the completion of testing. The pass or fail message is also
stored in Flash memory for later factory analysis.
5
Reloads the Cisco IOS software image.
If diagnostic testing was successful, and you do not specify the wait option, the Cisco
IOS software image is loaded from the RP to the card under test, bringing it back online.
Loading and Running Diagnostics
Procedures for loading and running diagnostic tests on a card in the router, including
sample console display messages, follow. You must run diagnostic tests from the system
console in privileged EXEC mode.
Summary of Contents for Gigabit Switch Router Cisco 12012
