Chapter 2 Installing the GoQAM
32
4004834 Rev D
Connecting the 10/100BaseT Ethernet Port
Follow these steps to connect the GoQAM to the Ethernet network.
1
Connect the DNCS to the ATM switch using multi-mode fiber.
2
Connect the ATM switch to the router using single mode fiber.
3
Connect the router to the 10/100BaseT Ethernet hub using CAT-5 Ethernet
10/100BaseT wiring with RJ-45 connectors.
4
Connect the 10/100BaseT port on the GoQAM to the 10/100BaseT Ethernet hub
using CAT-5 Ethernet 10/100BaseT wiring with RJ-45 connectors.
Note: Use a screened or shielded cable to connect the GoQAM to the
10/100BaseT Ethernet hub.
5
Your next step is to provision the GoQAM on the DNCS. See
Provision the RF
GoQAM
(on page 37) or
Provision the IF GoQAM
(on page 53), for further
details about provisioning the GoQAM on the DNCS. Then, go to step 6.
6
After your have provisioned the GoQAM on the DNCS, power on the GoQAM
to ensure that the GoQAM boots correctly and check for alarms from the front
panel.
7
Go to
Connect the RF OUT or IF OUT Ports
(on page 33).
Summary of Contents for GoQAM
