2-7
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
OL-8677-01
Chapter 2 Installing IDS-4210
Installing the Accessories
For More Information
•
For the procedure for using HTTPS to log in to IDM, refer to
Logging In to IDM
.
•
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
–
Installing and Using Cisco Intrusion Prevention System Device Manager 5.1
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
5.1
Installing the Accessories
You can install a bezel, and center or front mounting brackets for the IDS-4210.
This section contains the following topics:
•
Accessories Package Contents, page 2-7
•
Installing and Removing the Bezel, page 2-7
•
Installing Center Mount Brackets, page 2-8
•
Installing Front Mount Brackets, page 2-10
Accessories Package Contents
The following items are shipped in the accessories package for IDS-4210:
•
Cisco IDS-4210 bezel
•
Power cable
•
Network patch cable
•
Computer interconnection cable
•
Dual serial communication cable
•
Rack mounting brackets
•
Documentation and software
–
Cisco IDS recovery/upgrade CD
–
Cisco Documentation CD
–
Documentation Roadmap for Cisco Intrusion Prevention System 5.1
–
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System 4200
Series Appliance Sensor
Installing and Removing the Bezel
You can install a Cisco bezel for IDS-4210.
To install and remove the bezel on IDS-4210, follow these steps: