2-8
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
OL-8677-01
Chapter 2 Installing IDS-4210
Installing the Accessories
Step 1
To insert the bezel on IDS-4210, follow these steps:
a.
Align the bottom tabs on the bezel with the slots on IDS-4210.
b.
Align the side tabs on the bezel with the slots on IDS-4210.
c.
Press the bezel into IDS-4210.
Step 2
To remove the bezel from IDS-4210, press the side tabs and pull.
Installing Center Mount Brackets
You need the following tools and supplies to install the brackets in a two-post, open-frame relay rack:
•
#2 Phillips screwdriver
•
Masking tape or felt-tip pen to mark the mounting holes to be used
To install the center mount brackets in a two-post, open-frame relay rack, follow these steps:
Step 1
Determine where you want to place IDS-4210.
Step 2
Mark the upper and lower mounting positions on the two posts.