3
Get Connected
Prepare Your Jawbone ICON
Press and hold the
Talk Button
while sliding on
your Jawbone ICON until the LED flashes
Red+White
. This indicated that the Jawbone ICON
is ready to connect (paring mode).
Prepare Your Phone
Turn on the Bluetooth settings.
On a Bluetooth-Enabled Cisco Unified IP
Phone
Review the User Guide for your IP phone if the
Jawhone ICON headset and IP phone are not
already connected.
On an iPhone
Go to
Settings > General
and enable
Bluetooth
.
On a Blackberry
Go to
Settings/Options > Bluetooth
and enable
Bluetooth
.
Other Cell Phones
Go to
jawbone.com/paring
or review the
instruction manual that came with your phone.
Make the Connection
Go to your phone’s Bluetooth settings.
Add or Search for Devices
When “Jawbone ICON for Cisco” appears, select
it.
If asked for a passcode
, enter “
0000
”.
This is a one-time event you should now have to
repeat, unless you are connecting your Jawbone
ICON headset to another phone.
4
Talking Points
Answer/End a Call
Press the
Talk Button
on your Jawbone ICON to
both answer and end a call.
Decline an Incoming Call
Hold the
Talk
Button
for 2 seconds.
Make a Call
Use your phone to dial as usual. Listen and talk
through your Jawbone ICON.
Activate Voice Dialing
Hold the
Talk Button
until you hear a beep and
then release.
Redial Last Number
Press the
Talk Button
twice.
Simultaneous Calls
To switch between calls, press the
Talk Button
. To
end one call and switch to the other, press the
Talk
Button
twice.
Adjust the Volume
Press and hold the Talk Button and the volume
level will cycle up and down. When you find the
most comfortable volume level, release the button
and your volume will be set. Or just use the volume
control on your phone.
Mute a Call
Use your phone to place a call on mute.
5
Power Up, Etc.
Get Juiced
Your Jawbone ICON is partial charged and ready
for use right out of the box.
To Hear Remaining Battery Life
Press the
Talk Button
when not on a call.
When Battery is Low
The LED indicator flashes
Red
.
For a Full Charge
Plug it in.
When Fully Charged
The LED indicator turns
White
.
Note
It takes 40 minutes to get your Jawbone
ICON 80% charged. A full charge takes
90 minutes.
Tech Specs
•
Talk Time
: Up to 4.5 hours
•
Standby
: More than 10 days
•
Range
: 33 feet (10 meters)
•
Micro-USB standard connector interface
•
Bluetooth 2.1 +_ EDR
•
Packaging 100% recyclable
Tip
To avoid potential interference issues
between Bluetooth headsets and other
wireless devices, use the Cisco Unified IP
phone on the same side of your body as the
headset.
6
Safety Information
Warning
Failure to follow these safety
instructions could result in hearing
damage, or in fire, electric shock, or
other injury or damage.
Avoiding Hearing Damage
Permanent hearing loss may occur if the Jawbone
ICON headset is used at a high volume. Set the
volume to a safe level. Even though you may
become accustomed to a higher volume of sound,
and even though it may sound normal, any higher
volume of sound can be damaging to your hearing.
If you experience ringing in your ears or muffled
speech, stop listening and have your hearing
checked. The louder the volume, the less time is
required before your hearing could be affected.
