SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide
218
B
Voice tab > SIP page
Auto Attendant Parameters section
AA Dial Plan 1
Dial Plan 1 to be used in an AA script. Example: <dialplan
src=dp1/>.
Default:
(10x|xxx.)
AA Dial Plan 2
Dial Plan 2 to be used in an AA script. Example: <dialplan
src=dp2/>.
Default:
(<:10>x|xxx.)
AA script 1/2/3
AA script. See
Chapter 7, “Configuring the Auto Attendant”
,
for the complete syntax.
Default:
<aa><form id="dir" type="menu"> <audio src="prompt1"
bargein=
"T"/> <noinput timeout="10" repeat="T"/> <nomatch
repeat="F">
<audio src="prompt3" bargein="T"/> </nomatch> <dialplan
src=
"dp1"/> <match> <default> <audio src="prompt2"/> <xfer
name=
"ext" target="$input"/> </default></match> </form></aa>
Daytime AA
To enable the daytime Auto-Attendant, select yes. Otherwise,
select no.
Default:
yes
Day Time
Daytime hours for the daytime Auto-Attendant in 24-hour
format. Enter the start and end times in this format:
start=hh:mm:ss;end=hh:mm:ss (hh for hours, mm for minutes,
and ss for seconds).
For example, start=9:0:0;end=17:0:0 means that the start time
is 9 AM and the end time is 5 PM. The other hours (5 PM to 9
AM) are considered nighttime hours.
If you do not enter start and end times, the whole day (24
hours) is considered as daytime, so the nighttime Auto-
Attendant is not used, even if it is enabled.
DayTime AA Script
Specifies which AA script (1, 2, or 3) is used for the AA
treatment when operating in daytime mode.
Default:
1
Downloaded from
www.Manualslib.com
manuals search engine
