S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
4-20
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 4 C Commands
cfs static-peers
cfs static-peers
To enable static peers interface, use the
cfs static-peers
command. To disable this feature, use the
no
form of the command.
cfs static-peers
no cfs static-peers
Syntax Description
This command has no arguments or keywords.
Defaults
Enabled.
Command Modes
Configuration mode.
Command History
Usage Guidelines
This command enables the static peers with status and all the peers in the physical fabric.
Note
The
no cfs static-peers
displays a warning string, and changes the entire fabric from static to dynamic.
Examples
The following example shows how to enable static peers interface:
Switch(config)#
cfs static-peers
Warning: This mode will stop dynamic discovery and relay only on these peers.
Do you want to continue?(y/n) [n] y
Switch(config-cfs-static)#ip address 209.165.200.226
Switch(config-cfs-static)#ip address 209.165.200.227
Switch(config-cfs-static)#exit
Switch(config)#
Related Commands
Release
Modification
4.1(1b)
This command was introduced.
Command
Description
show cfs static peers
Displays configured static peers with status.