![background image](http://html.mh-extra.com/html/cisco/mds-9000-series/mds-9000-series_command-reference-manual_21253653.webp)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
11-47
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 11 I Commands
ip address (interface configuration)
ip address (interface configuration)
To assign an IP address to a Gigabit Ethernet interface, use the
ip address
command in interface
configuration submode. To remove the IP address, us the
no
form of the command.
ip address
address netmask
no ip address
address netmask
Syntax Description
Defaults
None.
Command Modes
Interface configuration submode.
Command History
Usage Guidelines
None.
Examples
The following example assigns an IP address to a Gigabit Ethernet interface:
switch#
config terminal
switch(config)#
interface gigabitethernet 1/2
switch(config-profile)#
ip address 10.5.1.1 255.255.0.0
Related Commands
address
Specifies the IP address.
netmask
Specifies the network mask.
Release
Modification
1.1(2)
This command was introduced.
Command
Description
show fcip profile
Displays information about the FCIP profile.
interface fcip
interface_number
use-profile profile-id
Configures the interface using an existing profile ID from 1 to 255.
show interface fcip
Displays an interface configuration for a specified FCIP interface.