S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
18-14
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 18 P Commands
port
port
To assign the TCP port number of a Gigabit Ethernet interface to the FCIP profile or a listener peer port
for a ISCSI interface, use the
port
command. Use the
no
form of the command to negate the command
or revert to factory defaults.
port
number
no port
number
Syntax Description
Defaults
Disabled
Command Modes
Fcip profile configuration submode.
Interface configuration submode.
Command History
Usage Guidelines
Associates the profile with the assigned local port number. If a port number is not assigned for a FCIP
profile, the default TCP port 3225 is used.
Examples
The following example configures port 5000 on FCIP interface 5.
switch#
config terminal
switch(config)#
fcip profile 5
switch(config-profile)#
port 5000
The following example configures port 4000 on ISCSI interface 2/1.
switch#
config terminal
switch(config)#
interface iscsi 2/1
switch(config-profile)#
port 4000
Related Commands
port
number
Configures a peer port. The range is 1 to 65535.
Release
Modification
1.1(1)
This command was introduced.
Command
Description
show fcip profile
Displays information about the FCIP profile.
interface fcip
interface_number
use-profile
profile-id
Configures the interface using an existing profile ID from 1 to 255.
show interface fcip
Displays an interface configuration for a specified FCIP interface.