Cisco MGX 8260, Connecting Manual

5-9

Cisco MGX 8260 Hardware Installation Guide

78-10966-02

Chapter 5      Connecting the Cables

Connecting Fast Ethernet Cables

Connecting Fast Ethernet Cables

This procedure applies to systems that use Fast Ethernet interfaces on the SCC back card for VoIP
applications. Refer to

Appendix A, “Cable and Connector Reference,”

 for a cable wiring diagram. If

your system uses OC-3 interfaces, skip this procedure.

To connect 100BASE-TX Fast Ethernet cables, follow these steps:

Step 1

Connect the first network cable to an RJ-45 receptacle on the SCC back card in slot 9 (see

Figure 5-6

).

Figure 5-6

Connecting Fast Ethernet Cables

Step 2

Connect the other end of the cable to the appropriate network device.

Note

Fast Ethernet redundancy is achieved through the use of appropriately configured network devices.

Step 3

Repeat

Step 1

 and

Step 2

 for other Fast Ethernet cables.

Step 4

If your system has a redundant SCC, repeat

Step 1

 through

Step 3

 for the adjacent SCC.

BITS

CONSOLE

A

U

X

ALARM

MGMT

1

2

3

4

12

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

BITS

CONSOLE

A

U

X

ALARM

MGMT

1

2

3

4

12

RX

TX

6

RX

TX

1

RX

TX

2

RX

TX

3

RX

TX

4

RX

TX

5

33473

Fast Ethernet