2-54
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2
Shelf Management Commands
dspclksrcs
Display information on the clock sources. The display shows that nothing has been configured, so the
internal oscillator generates the primary and secondary clocks. The primary and secondary clock reason
is “okay” in each case.
Unknown.7.PXM.a > dspclksrcs
Primary clock type: null
Primary clock source: 0.0
Primary clock status: not configured
Primary clock reason: okay
Secondary clock type: null
Secondary clock source: 0.0
Secondary clock status: not configured
Secondary clock reason: okay
Active clock: internal clock
source switchover mode: non-revertive
Display information about the clock sources. This example shows a BITS clock for the primary source
with revertive mode enabled.
pop20one.7.PXM.a > dspclksrcs
Primary clock type: bits t1
Primary clock source: 7.35
Primary clock status: ok
Primary clock reason: okay
Secondary clock type: generic
Secondary clock source: 9:1.1:1
Secondary clock status: ok
Secondary clock reason: okay
Active clock: primary
source switchover mode: revertive
