4-3
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4
ILMI Commands
Identifying Physical and Logical Elements
•
Subport corresponds to the resource partition on the AXSM. For a UNI or NNI, this resource
partition is the same number as the logical port number (ifNum) on the AXSM. For a virtual
network-to-network interface (VNNI), the number does not directly correspond to the
For each physical port number, PNNI also generates a logical port number as an encrypted form of the
physical port number. The logical port number appears as an unformatted numerical string. For example,
a PNNI physical port ID may have the form 1:1.2:2, so the PNNI logical port number would be
16848898. Where needed, the descriptions in the PNNI command chapter define the need for this logical
port number. (This section does not define a PNNI logical port number, nor does it describe the
correspondence between an AXSM port and a PNNI logical port number.) For the correspondence
between a PNNI physical port and the port identifier on an AXSM, see
Table 4-1
.
As
Table 4-1
shows, a port to PNNI is a line on the AXSM, and a subport to PNNI is a logical interface
(or logical port) on an AXSM. An example of a PNNI physical port identifier is 1:2.1:1. This portid
corresponds to an AXSM, with the following particulars:
•
Slot 1
•
Bay 2
•
Line 1
•
Logical interface 1 (or logical port 1)
Table 4-1
Mapping PNNI Port ID to AXSM Elements
PNNI port
AXSM
Shelf
N/A
Slot
Slot
Subslot
Bay (for upper or lower back card)
Port
Line
Subport
Logical interface (or port)
